Easy Advice for Installing Storm Windows = Big Energy Savings This Winter

How to Install Storm WindowsWorried about winter heating bills? Or just wishing your home wasn’t so drafty? We’ve already covered the perfect DIY solution #1: installing storm doors. What’s the perfect DIY solution #2? Installing storm windows. They alone can save you between 12 and 33 percent on your heating costs and are much cheaper than replacement windows. Plus, installing storm windows is easy, with our expert how-to advice.

Make Your Choice – Interior or Exterior Storm Windows

Determine what type of storm windows you’d like – interior or exterior. Exterior models come with solid windows and screens in frames that attach directly to an existing window. Interior storm windows are usually seasonal products that you install every winter. They snap or clip into your interior windowsill but do not have adjustable glass panes or screens.

Exterior storm windows are the most common. Frames are made from wood, aluminum or vinyl and offer extra protection to your existing windows. They help them last longer and require less maintenance to the paint and caulk. Most have low emissivity glass (Low-E), which keeps thermal heat in during the winter and infrared heat out during the summer.

Installation is a simple DIY home project that you can tackle in a weekend (depending on the number of windows you have). To start, you will need the following:

Measure, Measure, Measure

Take a series of measurements of the inside of your existing window, at the bottom, top and middle of the frame. Why? The window frame may not be straight. Use the smallest measurement to order your storm windows. Measure the height of the frame from the outside of your window.

Consider ordering your windows with some of the following features:

  • Multiple positioning stops so you can raise or lower the panes to where you want.
  • Quality weather stripping to help stop heating/cooling loss.
  • Pre-drilled holes for quicker installation.
  • Easy-to-clean removable half pane glass and screens to make spring cleaning easier.

Drill Weep Holes then Paint

Storm windows come with weep holes installed at the bottom. Drill matching holes in the bottom exterior windowsill. This will allow condensation to escape. Next, scrap and paint the exterior frame before installing the new window.

Seal Your Storm Windows

Manufacturers recommend applying Butyl caulk, a rubber-based sealant that is good for outdoor installations like siding and gutters. It is a little uncooperative to work with, but it seals better than a silicone caulk. Apply it to the back of the storm window before installing to the exterior frame.

An Extra Set of Hands Comes in – Handy

You may need an extra set of hands to help hold the storm window while you mount it. First center the window then screw it in at top. Close the bottom sash and then screw the sides to the exterior frame. There will be an adjustable expander at the bottom of your storm windows. Tap it down tight against the windowsill and you are done.

Look for Condensation and Fix Air Leaks

Be sure to check your storm windows for condensation during the next cold snap. Leaks from your interior windows can cause moisture build up. This is no problem since the storm window has weep holes, but you may want to follow up with new weather stripping on your interior sill to plug possible air leaks.

Take a Bite Out of Your Next Power Bill

Cutting down on heating bills is always a challenge. Improving your home’s insulation, plugging air leaks and installing storm windows will go a long way to take a bite out of that next bill. Next time the cold wind blows and you sit warm inside, remember to thank your storm windows. Everyone likes a nice pat on the back from time to time.

Expert Advice

From ladders and drills to caulking saws, our expert staff is always on hand to help you find the right equipment to tackle your next DIY project. For more helpful tips on how to keep things warm at your house check out our blog, 3 Easy Economical Ways to Winterize Your Home. As always, if you have any questions about what to choose, pricing or how-to’s, don’t hesitate to contact us. Stop by our store — we’re open seven days a week.

Advertisements
Categories: DIY Projects, How-To's | Tags: , , , , , , , , | 1 Comment

Post navigation

One thought on “Easy Advice for Installing Storm Windows = Big Energy Savings This Winter

  1. Pingback: 8 Essential Best Practices for Efficient Heating This Winter | Runyon Equipment Rental Blog

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

Blog at WordPress.com.

%d bloggers like this: